-- Leo's gemini proxy
-- Connecting to gemini.mingmengtou.org:1965...
-- Connected
-- Sending request
-- Meta line: 20 text/gemini;lang=en-GB
when i seen anyone sewing with an overlocker (serger) i am amazed at what these do: securing the seam, the fabric edge, and cutting off excess fabric.
i reached the tipping point and bought a Bernina L460. another contender was a Bernette air threading overlocker. i stuck with the L460 decision because it has the same motor control as my Bernina 570QE - stitch by stitch from the foot controller, quieter operation.
dc motor
stitch by stitch control
bernina quality
bright lights
color coded thread paths that i can thread without difficulty
same eco-system as my other machines
cost - we get what we pay for generally. the L460 lacks air threading but i want to pay for quality results not extra features that don't directly effect the stitching.
off-cuts bin. widely reviewed as being difficult to remove - and it can be - until we work out how to remove it. i slip my fingers under the left edge of the bin and make a 'come hither' finger movement: bin pops off easily.
no air threading. this machine is not hard to thread manually - i got it first time with my big male fingers.
the free hand system arm is a different design from the 570QE arm, but these look very similar. the difference is in the lugs that slot into the machine: 570QE vertical, L460 horizontal. minor issue really as these machines both come with a FHS arm. i have limited working space at the moment so being able to use the same arm between machines could be useful.
a grub screw to lock the knife shaft is not properly accessible based on my first attempts. that said when i checked with the Bernina dealer none of their staff (sewists all) had even needed to use this function.
so far i have used the L460 to:
edge fabric before hemming
sew a large bolster pillow
sew pillow cases and pillow protectors
i bought the Mettler overlock thread kit with the machine (colors correspond to the thread paths) but after only a couple of weeks i have bought more neutral overlocker threads because the thread paths are easy to follow.
beyond one or two operator errors as i learn my technique the machine works flawlessly. i feel that i made the correct machine choice for my use cases. it even stitched flawlessly at the start when i had not noticed the clear plastic film over the upper thread runs that i should have removed when unpacking.
---
---
neil.gemini@mingmengtou.org
content licensed CC-BY-SA 4.0 unless stated.
-- Response ended
-- Page fetched on Wed May 1 23:52:36 2024
